Wolf · Phoenix
Cooktop Repair
Wolf gas, induction and electric cooktops and rangetops: spark electrodes, sealed burners, elements and glass touch controls.
$89 service call — the visit and the diagnosis, credited against the repair. Visits 8:00 am – 8:00 pm, seven days.
In your words
What people describe when they call about this
If one of these is close, say so on the phone — it usually narrows the likely part before anyone leaves the yard.
- “An induction zone shuts itself off a few minutes into a big pot”
- “The flame is yellow and leaves soot on the bottom of the pan”
- “The igniter keeps snapping away after the burner is already lit”
- “One element stays at full power however far I turn the knob”
What it comes to
What these repairs run, in ranges
Flat $89 service call covering the visit and full diagnosis, credited against the repair once you approve it.
The repair itself is quoted and agreed with you before a tool comes out — what failed, what putting it right takes, and what that totals. Approve it and the $89 comes off that total; decide against it and the service call is all you owe. The ranges below are parts and labour together, and which end of a band a job lands on comes down to the part and how much has to come apart to reach it.
- Igniter or spark module $170–$450
- Burner valve or orifice service $240–$600
- Oven thermostat or sensor calibration $200–$420
- Convection fan or motor $280–$700
- Control board or touch panel $470–$890
- Door hinge, glass or seal $280–$750
Worth the comparison: a comparable professional range, before installation and ventilation work runs $8,360–$18,800. That is the reason nearly everything on this list is worth putting right rather than replacing.
What the visit actually is
Four readings, then a part
Most of what people are told is a dead control board turns out to be a pressure, a resistance or a blocked port. So the call starts with instruments, in this order, and the number decides what comes off the van.
-
Gas side
Manometer on the manifold tap to read pressure in inches of water column, then again with every burner lit. A simmer that will not hold is far more often supply or a bypass setting than a dead valve.
-
Ignition
Spark gap and electrode condition, module output, thermocouple millivolts at the flame. Clicking that carries on after the flame is up is a switch or a grounded electrode, not the whole module.
-
Oven cavity
Probe on the centre rack through three full cycles against the setpoint, plus the sensor resistance cold. Drift and a hard sensor failure look identical on the panel and want different parts.
-
Air and heat
Convection blower current and rotation, door seal along the whole gasket, hinge tension, and for ventilation the blower draw plus static in the duct at the roof cap.
Work is carried out 8:00 am – 8:00 pm, seven days, and the $89 service call is credited against whatever the repair comes to.
Reviews
What people said afterwards
Wolf cooking calls in Arcadia, Biltmore, North Central Phoenix and Ahwatukee.
4.9/ 51,487 reviews
Our cooktop tripped the breaker whenever the second zone came on. He traced a chafed harness rubbing against the trim rail, pinched during the remodel years ago. Rerouted, sleeved, no trips since.
Solange M.Biltmore
Sparking would not stop on the back burners once they lit. Grit had worked into an electrode, which happens here after a haboob. Replaced one, cleaned the rest; it took two visits to chase down.
Teodoro S.Ahwatukee
One rangetop burner would only stay lit with the knob held down. The thermocouple was coated after a boil-over. He cleaned and reseated it, then checked the other three while he was here.
Amrit D.Arcadia Lite
The work
Other work we take on this equipment
-
Range Repair Dual-fuel and all-gas Wolf ranges: ignition and burner faults, simmer that will not hold, griddle heat and dead oven cavities. “A burner sparks away for a minute and never catches”“No usable simmer — the low setting either roars or drops out” -
Oven Repair Wolf built-in wall ovens, steam ovens and warming drawers — temperature drift, convection failures, door latches and panels that lock out. “It preheats for an hour and still sits well under the set temperature”“The convection fan grinds, then stops part way through a bake” -
Range Hood Repair Wolf ventilation hoods, liners and inserts — blower motors, speed switches, baffles, lighting and the ductwork above them. “Grease and smoke drift into the next room instead of going up”“Only half the lamps come on, and those flicker”
Describe the fault. We will tell you what it usually is.
cooktop repair in Phoenix, AZ. Call and describe the symptom, or take a slot on the booking page — there is no form to fill in on this site.